Royal RGPRO Installationshandbuch

www.royallgrills.com 325 South Park Street Reedsburg, WI 53959 Phone 608-768-8508

NumbersWhen the grill is connected to AC power, the model numberand software version of the control are displayed momentarily.Temperature In cook mode

Turn the Grill O Set the cook control switch to the o position.Plug the Grill In Connect the grill to AC power. The control displays its model nu

Temperature Settings180 180 degrees225 225 degrees250 250 degrees275 275 degrees300 300 degrees325 325 degrees350 350 degrees375 375 degreesHigh 450 d

Smoke Control Set the cook control switch to smoke. Use the smoke control switch to manually select the auger fuel feed rate. The control displays th

“P” Settings The fuel feed rate setting is displayed momentarily whenever the cook control switch is set to the smoke position. It is also displayed w

Smoke Mode Fuel Feed RateIn smoke mode, increasing the “P” setting decreases the fuel feed rate, lowering the grill temperature. Start at setting “P2

WIRING DIAGRAM 14

AC Auger The grill is equipped with an AC auger. AC augers operate at a single speed and deliver fuel at a constant rate whileon The fuel feed rate

Always disconnect the grill from AC power before accessing the control for service or working under the grill.Removing the control from the grill,

Fire Goes Out Set cook control switch to the o position and allow grill to cool.No fuel in hopperFill hopper with good, dry fuel.No fuel in  repotV

CONTENTMAJOR FEATURES ...

Unexpected Temperature DisplayedAuger idle fuel feed rate is too high. Adjust smoke control switch (increase the “P” setting) to decrease idle fuel

1The RG-Digital Control is a plug-compatible replacement part for the Royall Standard 3-Speed Control and is compatible with the entire line of Royal

Required ToolsMedium Phillips screwdriverSmall slotted screwdriverPower Screwdriver 1/4” Only Unplug the Grill Unplug the grill from AC power. AC powe

Remove the ControlRemove the faceplate screws using a medium phillipsscrewdriver. Save the screws for use later. Gently pull thecontrol forward, rot

Position The ProbeOpen the cook lid. Locate the probe’s mounting holes.Feed the probe’s wire lead down through the shaft holeand out through the wire

Control Wiring Harness Grill ComponentPlug with Red Wire Fuel Feed AugerPlug with Orange Wire Draft FanPlug with Purple Wire IgniterPlug with Bla

Connect Control’s Black Wire to AC PowerOrganize Wire Lead If necessary, use the tie wrap to tie back the temperatureprobe wire lead and the control’s

LED ReadoutDisplays grill temperature, smoke settings, idle fuel feed settings, igniter status, low temperature status, and error messages.Cook Contro